PPG Aerospace® P/S 870 C-12 Gray MIL-PRF-81733D Type IV-12, Class 1, GA Spec Corrosion Inhibitive Sealant - Pint A+B Kit - Part#: 0870C012MP012PT
Enjoy superior protection against corrosion caused by moisture when you order PPG Aerospace®P/S 870 C-12 Corrosion Inhibitive Sealant. The sealant is sold in a pint-size A+B kit and is remarkably easy to use. The kit allows the individual components of the sealant to be kept completely separate until just prior to use. This ensures the sealant is at its peak when you're ready to use it, adhering well and completely sealing cracks, gaps or seals while blocking moisture from reaching the surface. The type IV-12 sealant is priced competitively and quantity discounts are available on qualifying orders.
Warning: This product may contain a chemical known by the State of California to cause health issues. Details found here www.P65Warnings.ca.gov
Note: The application and performance property values above are typical for the material, but not intended for use in specifications or for acceptance inspection criteria because of variations in testing methods, conditions and configurations.
Immediately before applying sealant to primed substrates, the surfaces should be cleaned with solvents. Contaminants such as dirt, grease, and/or processing lubricants must be removed prior to sealant application.
A progressive cleaning procedure should be employed using the appropriate solvents and new lint free cloth (reclaimed solvents or tissue paper should not be used). Always pour solvent on the cloth to avoid contaminating the solvent supply. Wash one small area at a time.
It is important that the surface is dried with a second clean cloth prior to the solvent evaporating to prevent the redeposition of contaminants on the substrate.
Substrate composition can vary greatly. This can affect sealant adhesion. It is recommended that adhesion characteristics to a specific substrate be determined prior to application on production parts or assemblies.
For a more thorough discussion of proper surface preparation, please consult the SAE Aerospace Information Report AIR 4069. This document is available through SAE, 400 Commonwealth Avenue, Warrendale, PA 15096-0001.
P/S 870 Class C is supplied in a two-part kit. Mix according to the ratios indicated in the application properties section. Mix Part A and Part B separately to uniformity, then thoroughly mix entire contents of both parts of the kit together taking care to avoid leaving unmixed areas around the sides or bottom of the mixing container.
The storage life of P/S 870 Class C is at least 6 months when stored at temperatures below 80°F (27°C) in original unopened containers.
This product is safe to use and apply when recommended precautions are followed. Before using this product, read and understand the Material Safety Data Sheet (MSDS), which provides information on health, physical and environmental hazards, handling precautions and first aid recommendations. An MSDS is available on request. Avoid overexposure. Obtain medical care in case of extreme overexposure.